Frigidaire CFRE4120SW Manual De Uso página 12

INSTALLATION INSTRUCTIONS
Electrical connection (non-Canada) - 4 wire cord
4-wire receptacle
(NEMA type 14-30R)
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing could
result in personal injury or even death.
1 Turn off power supply to outlet.
2 Remove the screw securing the terminal block access
cover in the upper corner on the back of the dryer.
3 Install a UL-approved strain relief according to the
power cord/strain relief manufacturer's instructions in
the power cord entry hole below the access panel. At
this time, the strain relief should be loosely in place.
4 Thread an UNPLUGGED, UL-approved, 30 amp. power
cord, NEMA 14-30 type ST or SRDT, through the strain
relief.
5 Disconnect the internal (WHITE) dryer harness ground
wire from the (GREEN) ground screw next to the
terminal block.
6 Attach the ground (GREEN) power cord wire to the
cabinet with the ground (GREEN) screw. Tighten the
screw securely.
7 Move the internal dryer harness ground (WHITE)
wire to the terminal block and attach it along with the
neutral (WHITE) power cord wire conductor to the
center, SILVER colored terminal on the terminal block.
Tighten the screw securely.
8 Attach the RED and BLACK power cord conductors to
the outer, BRASS colored terminals on the terminal
block. Tighten both screws securely.
WARNING
ELECTRICAL SHOCK HAZARD
Do not make a sharp bend or crimp wiring/conductor at
connections.
9 Follow manufacturer's guidelines for fi rmly securing the
strain relief and power cord.
10 Reinstall the terminal block cover.
12
30 AMP 30 AMP
NEMA 14-30 NEMA 14-30
Terminal
cover
Neutral
terminal
BLACK
or RED
power wire
GREEN
ground screw
GREEN
ground wire
Neutral Neutral
(WHITE wire) (WHITE wire)
Ground Ground
(GREEN wire) (GREEN wire)
Move internal ground (WHITE)
wire to neutral (center) terminal
for 4-wire system.
BLACK
or RED
power wire
WHITE
neutral wire