Descargar Imprimir esta página

Peavey XR 600G Manual De Operación página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

1.
Connect speakers to your XR600G. Route speaker cable for safety‚ taping down if necessary.
2.
Be certain that all levels are down and your EQ is flat.
3.
Connect all microphones and instruments. Turn on power to the XR600G and set master controls to the 12:00
position.
4.
Use mode switch to select both power amplifiers for main speakers or one amplifier for mains and one amplifier for
monitors.
5.
Adjust channel level controls for proper volume mix. Engage pad switches if a channel distorts or if the channel
becomes loud very quickly as its control is turned up.
6.
Adjust graphic and channel EQ as needed.
7.
Set and adjust the effects settings and channel send.
8.
Now‚ play like you've never played before. Have fun!
The standard channels (1–6) feature discrete‚ low-noise mic preamps with globally-switched phantom power and a 3-band EQ.
Channels 1–4 offer balanced 1/4" line-level inputs and feature a full 25 dB pad switch to accommodate a wide range of input signals.
Finally‚ channels (5–7) have dual input jacks (summed) for your tape‚ CD or synth input.
The master section features a DSP-based digital effects processor. This processor includes 16 presets‚ that provide a selection of
effects designed to enhance your sound. There is also a parameter control that allows you to set the Time/Size of the effect.
QUICK SET-UP GUIDE
XR 600G Front Panel
5

Publicidad

loading