Peavey XR 600G Manual De Operación página 9

15. EFX Defeat: Depressing this button defeats the Effects. The effects may also be defeated via the footswitch input (32).
16. EFX Select: This rotary switch selects one of sixteen available effects. See the table below.
Effect
1 Hall Rev
2 Large Hall Rev
3 Room 1 Rev
4 Room 2 Rev
5 Plate 1 Rev
6 Plate 2 Rev
7 Cathedral
8 Spring
9 Delay 1
10 Delay 2
11 Delay 3
12 Tape Delay
13 Doubler
14 Shimmer
15 Vocal Enhancement 1
16 Vocal Enhancement 2
17. Effects Input CLip LED: This red LED illuminates to indicate 6 dB of headroom before the signals being sent to the
effects circuit are clipped. Ideally‚ you want this LED to light only occasionally. An occasional blink indicates that your
levels are set optimally. Listen carefully to the output to determine the final setting.
18. EFX Time: This control adjusts the time of the particular reverb or delay.
19. EFX to Monitor: This control adjusts the amount of effects signal sent to the monitor mix. This allows effects to be
heard from the stage via the monitors. Keep this control as low as possible.
20. EFX to Main: Adjusts the amount of effects sent to the main mix. Controls the amount of effects sent to the front-of-
house mix. Remember: A little goes a long way!
21. FLS ® Feedback Locating System: When feedback occurs‚ the corresponding LED of the frequency band that is
feeding back will illuminate over the slider to be adjusted. Slowly bring the corresponding slider down until the feedback
is gone. The LED will remain illuminated for a few seconds after the feedback is gone. If the feedback doesn't return‚ all
the LEDs will become active again acting as a normal EQ.
22. Power LED: This LED illuminates when power is supplied to the XR600G.
23. EQ Assignment: This switch allows you to patch the second (top) EQ to either the Monitor or to Channel 1. The
default position is the Monitor mode. This is indicated by the illuminated green LED. Push the button to change this to
the Channel 1 mode and the yellow LED lights. This is a great feature to use if you have a critical instrument such as an
acoustic guitar or a lead vocal. You can assign the top 9-band EQ to this channel! Although‚ keep in mind that this
eliminates the EQ for your monitors.
Description
Medium Concert Hall
Larger Concert Hall Darker
Intimate Room Bright
Larger Room Darker
Bright
Darker
Large Space, Long and Darker
Classic Spring
Single Delay (Slap-back)
Warm Delay with Repeats
Dark Delay with Repeats
Warm Delay
Single Delay, 30 - 120 ms
Warm Delay with Modulation
Brightens and adds Room Reverb
Brightens and adds Spring Reverb
9
Application Parameter
Ensemble
Gen Reverb
Pop Vocal
Drums,Rhythm
Pop Vocal
Drums
Choir
Guitar
Voc/Instr
Instruments
Instruments
Instruments Dly Time/Feedback
Instruments
Instruments
Vocals
Vocals
Rev Time
Rev Time
Rev Time
Rev Time
Rev Time
Rev Time
Rev Time
Rev Time
Dly Time
Dly Time
Dly Time
Dly Time
Dly Time
Rev Level
Rev Level