Safety Instructions - swissflex uni 12_75K bridge Modo De Empleo

uni 12_75K bridge
Cable remote control
1 Back section «up»
2 Back section «down»
3 Leg section «up»
4 Leg section «down»
5 Reset / All motors «down»
Motor housing (on uni 12_75K)
6 Connector for cable remote control
7 Connection for mains supply unit /
mains cable
Comfort and health
Welcome to the world of Swissflex!
Your Swissflex uni 12_75K is a Swiss quality product.
If you follow the simple operating and safety instruc-
tions, it will function to your complete satisfaction
for many years. In addition to its many other advan-
tages, your uni 12_75K offers an undisturbed sleep
environment. All electrical connections between the
mains plug and the bed are virtually free of mains
voltage (below 0.5 watts) thanks to EcoTec.

Safety instructions

CAUTION! The uni 12_75K and accessories must be
protected from rain and other moisture to prevent
causing a fire hazard or the risk of electric shock.
When installing the slat base, ensure that the head,
10
Operating instructions
®
1
3
5
back and foot sections are not obstructed by furni-
ture.
Ensure that the mains supply is disconnected before
any assembly or disassembly work is carried out on
the slat base or the bed frame.
Handle the uni 12_75K and accessories with care; do
not disassemble or modify them, do not allow child-
ren to play with them and prevent frail individuals
from using the product without supervision.
The product may not be used with a medical device
or be installed in a medical device.
The product may not be used in an environment in
which flammable or explosive gases or vapours (e.g.
anaesthetics) are likely to occur.
The product may not be used to raise and lower
loads. Only use spare parts that have been produced
or a proved by Swissflex. Only these parts guarantee
adequate safety.
2
4
EN