Tabla de contenido
Publicidad
40
E
INSTALLING THE SOFTWARE (Macintosh)
This section describes how to install the utility software
included with your Floppy Disk Adaptor.
1 Start up your computer.
2 Insert the Macintosh utility software setup disk (FPD-2ME)
into you floppy disk drive. (If you downloaded the program
from a web site, locate the installer file.)
3 Double-click the "FPD-2ME" icon.
5 The installer starts up; to continue with the installation,
follow the instructions displayed on-screen.
"ReadFlashPath" utility software icon
6 After the installation is completed, double-click
"ReadFlashPath" to run the data read utility.
CAUTION
Avoid installing the same data read utility program
more than once. If two (or more) FlashPath data
read utility programs are inadvertently running
concurrently, it could damage the floppy disk
adaptor or SmartMedia disk.
Publicidad
Tabla de contenido
