Bissell READYCLEAN POWERCLEAN POWERBRUSH pet 47B2 Serie Guia Del Usuario página 5

A
ssembly
Your deep cleaner assembles quickly
and easily. The only tool you will need
for assembly is a Phillips head screw-
driver.
1. slide upper body onto lower body.
2. secure with screws.
3. slide upper handle into upper body by
aligning the pin and sliding into place.
NOTE: Be sure to secure
upper handle before lifting.Rotate
handle lock clockwise to secure.
4. Place solution tank on back of unit.
5. Wrap power cord.
Assembly is now complete.
O
perations
Before you clean
1. move furniture to another area if
cleaning an entire room. (optional)
2. Vacuum carpet thoroughly.
3. Plan your cleaning route to leave an exit
path. it is best to begin cleaning in the
corner farthest from your exit.
4. Pre-Treating (optional) Pre-treat
stubborn stains and highly soiled carpet
in hallways and other high-traffic areas.
4a. generously spray bissell tough stain
Pretreat evenly over soiled area.
Caution: DO NOT OVER WET
CARPET
4b. Wait 3-5 minutes before deep cleaning.
Fill the tank
1. Remove the solution tank by lifting it
straight up, then away from the
lower body.
2. unscrew the black cap at the bottom of
the solution tank.
w w w . b i s s e l l . c o m
1.
3.
pin
WARNING:
to reduce the risk of fire, use
only bissell advanced deep
cleaning formula for full size
machines in your deep cleaner.
use of cleaning formulas that
contain lemon or pine oil may
damage this appliance and void
the warranty. chemical spot
cleaners or solvent-based soil
removers should not be used.
These products may react with
the plastic materials used in your
deep cleaner causing cracking or
pitting.
1.
8 0 0 . 2 3 7 . 7 6 9 1
2.
4.
2.
5