Publicidad
Idiomas disponibles
Idiomas disponibles
3. Installation of A1, A2, A3, and A5
Important!
• The mixers are designed for a water pres-
sure of minimum 1 bar and maximum 5 bar.
• Maximum water temperature must not ex-
ceed 80°C. Recommended, maximum
water temperature: 65°C.
• Enamel surfaces may be damaged when
using sharp tools. Therefore, use felt-coated
or plastic-coated tools.
All kitchen, bidet and wash basin mixers are
delivered with copper tubes. To avoid leaking,
please observe below instructions:
• If you need to shorten the tubes, use a tube
cutter. Do not use a saw/hacksaw.
• For tube connections, use a quick-coupling.
Do not connect by soldering.
• The tubes can be moderately bent to facil-
itate installation.
The tubes must not be turned!
Mounting of mixers on table top
The diameter of the hole of each mixer is stated
in the table with dimensions (see page 3).
Remove all burrs from edge of hole
4
All A1 and A3 models are available with or without
rosette.
Mounting of swivel spout on mixer
Publicidad
