Maintenance; Motor Seal; Locking Washer; Blades - Robot Coupe CL 40 Manual De Instruccion

MAINTENANCE

• MOTOR SEAL

The motor seal on the shaft should be lubricated re-
gularly using a food safe lubricant.
In order to keep the motor completely watertight, it
is advisable to check the motor seal regularly for
wear and tear and replace if necessary.
The motor seal can be easily replaced without ha-
ving to remove the motor, so we strongly advise you
to ensure that is in good condition.

• LOCKING WASHER

To ensure that your appliance continues to run
smoothly, we recommend that you regularly check
the locking washer for wear and tear.
If the washer becomes worn, we therefore advise
you to replace it.

• BLADES

The blades of the slicing discs of the dicing
and french fry kits are wearing parts that must be
replaced from time to time, in order to maintain
optimum cutting quality.

• GRATING, JULIENNE AND RIPPLE-CUT DISCS

The grating, julienne and ripple-cut discs gradually
become blunt and should be replaced from time to
time to maintain optimum cutting quality.coupe.
TECHNICAL
SPECIFICATIONS

• WEIGHT

Net
CL 40 (without disc) 16 kg
Disc 0.5 kg
• DIMENSIONS (in mm)
E
H
F
D
A
B
C

• WORKING HEIGHT

We recommend that you position the CL 40 on a
stable worktop so that the upper edge of the large
feed hopper is at a height of between 1.20 m and
1.30 m.

• NOISE LEVEL

The equivalent continuous sound level when the
CL 40 is operating on no-load is less than 70 dB
(A).

• ELECTRICAL DATA

Single phase machine
Motor
Gross
230 V/50Hz
18 kg
0.6 kg
240 V/50Hz
120 V/60Hz
220 V/60Hz
- Power shown on data plate.
G
The CL 40 is fitted with a magnetic safety device
CL 40
and motor braking system.
A 225
As soon as you open the lid, the motor stops.
B 303
C 224
To restart the machine, simply close the lid and
D 590
E 345
press the green switch.
F 745
G 530
W A R N I N G
H 410
The discs are extremely sharp. Handle with care.
The CL 40 is fitted with a thermal cut-out which
automatically stops the motor if the machine is left
on for too long or overloaded.
If this happens, allow the machine to cool comple-
tely before restarting.
Speed Intensity
(rpm) (Amp)
500 5.4
500 5.4
600 12.0
600 5.4

SAFETY

19