Nozzle Connection - Mi-T-M Corporation LV Serie Manual De Instrucciones

CONNECTION OF Q.C. NOZZLES
QUICK-CONNECT (Q.C.) NOZZLES
WARNING
RISK OF SEVERE INJURY!
THE TRIGGER GUN SHOULD
ALWAYS BE LOCKED IN THE OFF
POSITION WHEN NOT IN USE!
12
INSTALLATION & PREPARATION
NOZZLE REVIEW (CONT'D):
C. QUICK CONNECT NOZZLE: Various nozzles may be quick-
connected into the end of the wand to change the spray pattern or use
the detergent feature. When using Quick Connects (Q.C.), be certain the
connection is securely locked. If not, the high pressure water may shoot
the nozzle from the wand, causing severe injury or serious damage. To
determine spray fan, refer to the actual number stamped on the nozzle.
The first two digits indicate the spray fan in degrees, i.e.; 00=0°, 15=15°,
25=25°, 40=40°, 65=detergent/low pressure. (NOTE: Not all nozzles are
incuded with the pressure washer.)
1. The 0° nozzle (RED): This is a blasting nozzle.
Be cautious when using this nozzle as it delivers a very
concentrated stream of water. It is not recommended for
use on painted or wood surfaces, or items attached with
adhesive backings. Uses: Removing weeds from
sidewalk cracks, stubborn stains from concrete, masonry,
aluminum and steel, caked mud from equipment, and
cleaning lawn mower undersides.
2. The 15° nozzle (YELLOW): This is a chiseling nozzle.
The spray should be directed at a 45° angle to the
surface and used like a scraper to remove paint, grease
and dirt. Uses: Surface preparation (removing mildew
stains and paint chips).
3. The 25° nozzle (GREEN): This is a flushing nozzle.
This pattern is best suited for flushing dirt, mud, and
grime. Uses: Wet sweeping leaves from walks, curbs
and driveways, cleaning stable floors, washing swimming
pool bottoms, degreasing engines.
4. The 40° nozzle (WHITE): This is a wash nozzle.
This wide spray pattern disperses the water pressure
over a large area and is recommended for moderate
washing. Uses: Washing aluminum siding, vehicles,
spraying sidewalks, driveways, and patios.
5. The 65° nozzle (BLACK): This is a low pressure
detergent application nozzle. This broad spray pattern
distributes solution over vast areas under low pressure.
Uses: Detergent application, misting or rinsing.
LANCE CONNECTION:
1. Be certain the trigger gun is locked in the "OFF" position. See WARNING ,
left.
2. The nozzle assembly should be disconnected from the gun assembly at this
time by unscrewing the nozzle/lance assembly from the gun/lance assembly.
LANCE CONNECTION
Long Life Vertical LV-Series Operator's Manual