Install The Hood - Broan B5936SS Manual De Instrucciones

Ocultar thumbs Ver también para B5936SS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALL THE HOOD

(Ducted Installation Only)
1. Assemble (4) angle brackets to the lower hood mounting
locations using (8) M4 x 10mm pan head machine screws
(2 for each angle bracket).
(16) M4 x 10mm
PAN HEAD
MACHINE
SCREWS &
(16) M4
SERRATED
FLANGE NUTS
3 "
2. Determine dimension "H" based upon ceiling height and
height of hood installation above cooktop:
8-ft. ceiling
Hood 30" above cooktop H = 30"
Hood 32¼" above cooktop H = 27¾"
9-ft. ceiling
Hood 30" above cooktop H = 42"
Hood 36" above cooktop H = 36"
10-ft. ceiling
Hood 30" above cooktop H = 54"
Hood 36" above cooktop H = 48"
For 10-ft. ceilings: Purchase a 10-ft. flue extension (Model
FXN59SS) which includes (4) additional angle mounting
brackets, (1) longer upper flue, and additional mounting
hardware.
(8) M4 x 10mm
PAN HEAD
MACHINE
SCREWS
(8) M4 x 10mm
H
PAN HEAD
MACHINE
SCREWS
3. Attach the upper set of (4) angle brackets to the outside of
the lower angle brackets according to dimension "H". Use
(16) M4 x 10mm pan head machine screws and (16) M4
serrated flange nuts (4 at each angle bracket connection).
4. Attach the angle bracket assemblies to the upper hood
mounting locations using (8) M4 x 10mm pan head machine
screws (2 for each angle bracket).
For 10-ft. ceilings: Attach a third set of (4) angle brackets
to the inside of the second set of angle brackets using
hardware supplied.
METAL
DUCT
LOUVERS
METAL
DUCT
DAMPER /
DUCT
CONNECTOR
5. Measure the length of 6" round metal duct required from
the damper / duct connector to the ductwork rough-in in the
ceiling. Connect the duct to the damper / duct connector
and seal with duct tape.
6. Remove the protective coating from the inner the flue. Turn
the inner flue so that the louvers are at the bottom. Carefully
slide the inner flue down into the outer flue. Slide the flues
over the angle brackets. Make sure the side marked "front"
faces the control side of the hood. Feed the power cable up
through the flues.
MODEL B5936SS
Page 4
INNER
FLUE
POWER
CABLE
OUTER
FLUE
DUCT
TAPE

Publicidad

Tabla de contenido
loading

Tabla de contenido