Starting And Stopping Treatment - Philips BlueTouch PR3733 Manual Del Usuario

ENGLISH
14
2 Then wrap the extended lower back strip around your body.
3 Fasten the lower back strap with the Velcro strip at a width that feels
comfortable.
Positioning the upper back strap
1 To put the BlueTouch Pain Relief Patch in the upper back strap,
follow the same procedure as described in steps 1 and 2 in section
'Positioning the lower back strap' above.
2 Remove clothing from the area to be treated.
Note: Make sure the skin in the area to be treated is clean, entirely dry and
free from creams, lotions and other cosmetics.
3 Put on the upper back strap like a backpack. First, put one arm
through the shoulder sling on one side. Then do the same on the
other side.
Note: Make sure the BlueTouch Pain Relief Patch in the strap is located on the
area to be treated and the LED area is in contact with the skin.
4 Tighten the shoulder slings by pulling the elastic straps.

Starting and stopping treatment

The BlueTouch Pain Relief Patch has three modes and an 'off ' setting
(see chapter ' Treatment schedule and treatment modes'). Press the mode
button one or more times to select one of the three treatment modes.
When you press the mode button a fourth time, you switch off the
BlueTouch Pain Relief Patch.
1 Mode 1 (low): press once
2 Mode 2 (medium): press twice
3 Mode 3 (high): press three times
4 O (off): press four times
Note: If you want to switch from mode 3 to mode 1 or 2 or from mode 2 to
mode 1, you have to press the mode button as many times as required to
reach the mode you want to select.