After Treatment; Cleaning - Philips BlueTouch PR3733 Manual Del Usuario

In mode 1 (low), four rows of LEDs light up in power-save mode.
,
The BlueTouch Pain Relief Patch beeps once.
Note: After 10 seconds the light intensity slowly increases from power-save
mode to the intensity of the mode selected. Put the BlueTouch Pain Relief Patch
on the treatment area within these 10 seconds.
In mode 2 (medium), six rows of LEDs light up in power-save mode.
,
The BlueTouch Pain Relief Patch beeps twice.
In mode 3 (high), all LEDs light up in power-save mode.
,
The BlueTouch Pain Relief Patch beeps three times.
When the light intensity starts to increase, you hear a dual tone from
,
low to high.
The BlueTouch Pain Relief Patch automatically switches off after the
,
treatment time of the selected mode has elapsed. You hear a triple
tone from high to low to indicate that the device has switched off.
Note: If you want to switch to another mode during treatment, for instance
because you experience the current intensity as unpleasant, press the mode
button one or more times to select another mode. The timer automatically
recalculates the remaining treatment time based on the new mode.
Note: If you want to switch off the device before the treatment time has
elapsed, press the mode button one or more times until the LEDs switch off
and you hear a triple tone from high to low.

After treatment

1 Loosen the strap and remove it from your back.
2 Recharge the BlueTouch Pain Relief Patch if the charging light is solid
orange (see chapter 'Charging the device'). Remove the BlueTouch
Pain Relief Patch from the strap before you start to recharge it.

Cleaning

Do not immerse the BlueTouch Pain Relief Patch in water or rinse it
under the tap.
Always remove the BlueTouch Pain Relief Patch from the strap before
you put the strap in the washing machine to clean it.
ENGLISH
15