Operation; Cleaning; Motor Unit; Blade - Robot Coupe Blixer 3 D Serie Manual De Instrucciones

THE UNIT SHOULD BE OFF EXCEPT WHEN
PROCESSING IS UNDERWAY. It is recommended
that the machine be operated on a 50% duty
cycle. This is easily accomplished since the
preparation time (cleaning, coring, peeling, and
loading) takes longer than the processing time.
This will increase the life of your machine.
When running frozen products in the bowl
attachment, the size of the product should not ex-
ceed 1 inch (2.5 cm).
®
The Blixer will enable you to perform all your
cutting tasks in minimum time ; we recommend
therefore that you keep a close eye on the mixture
in order to obtain the desired results.
HOSPITAL USES:
SPOON FEEDING
• Minced foods: meat, fish... • Vegetable purees
• Mousses: vegetables, fish... • Compotes of stewed fruit
SEMI-LIQUID FEEDING
This simply entails diluting spoon-feeding preparations:
• Minced meat + gravy • Puree + liquid (broth, milk...)
• Soups / creamed soups • Fruit compotes + syrup or water
LIQUID FEEDING (for use via tubes)
• Soups and any preparations that can be liquidized.
RESTAURANTS AND DELICATESSEN:
• Butter mixtures: snail butter, salmon butter, anchovie butter...
• Sauces: green sauce, mayonnaise, remoulade, ailloli, emulsify
sauces with tomatoes, cream, parsley...
• Grinding for bisque: lobster, scampi, seashells...
• Grinding: herbs, seeds, powders....
• Mixing: homogeneization of creams, mixed components,
varied ingredients...

OPERATION

W A R N I N G
As a precaution, always unplug your appliance
before cleaning it (risk of electrocution).

• MOTOR UNIT

Never immerse the motor unit in water. Clean it
with a damp cloth or sponge.
I M P O R T A N T
Check that your detergent is suitable for
cleaning plastic parts. Some washing agents
are too alkaline (e.g. high levels of caustic
soda or ammonia) and totally incompatible
with certain types of plastic, causing them to
deteriorate rapidly.
Cleaning of the motor base assembly must be done
with care.
First unplug the unit. A sponging with a cloth lightly
soaked (not dripping) in a mild detergent is accep-
table, making sure the water is not permitted to
penetrate the shaft seal or around the switches.
Clean around the shaft seal with a small brush,
taking care to remove all food. Do not forget to clean
the motor shaft. Rinse the motor base first using a
cloth lightly dampened (not dripping) with water,
then with a sanitizing solution, and dry the machine
with a soft cloth removing all liquids from seal areas.
WARNING: NEVER USE PURE BLEACH.
Always dilute the detergent following the instructions
given by the manufacturer.
Clean per the following instructions or as required by
local health department regulations.

CLEANING

• BLADE

The blade cap should be removed for cleaning
if necessary. Wear cut-resistant gloves when
removing the cap. Put a screwdriver or similar tool
into the blade assembly from the bottom, and knock
the cap out the top.

• WIPER ASSEMBLY

To clean the wiper assembly, dismantle it as follows:
- Hold the scraper in one hand and the handle in
the other hand (drawing 1).
- Press the metallic knob included in the handle,
pull the handle up (drawing 2).
- Then it is possible to dismantle the Wiper assembly
from the lid to clean it (drawing 3).
Drawing 1
Drawing 3
The bowl, blade, cap, lid, and wiper assembly are
dishwasher safe. They can be washed in a dish
machine or three-tank system pot sink. Pre-rinse the
attachments before washing to remove any bulk
Drawing 2
7