Keys For The Illustrations; For Cooling Units With Valve Couplings - Dometic ColdMachine 50 Instrucciones De Montaje Y De Uso

Installing the cooling unit

Keys for the illustrations

No. in fig. 8,
page 5
1
2
3
4
5
No. in fig. 9,
page 6
1
No. in fig. 0,
page 6
1
No. in
fig. i, page 9 and
fig. j, page 9
1
2
3
4
A
NOTICE!
Carefully insulate and seal off the wall openings after installation to
prevent moisture penetration.

For cooling units with valve couplings

➤ Cut out a hole with a diameter of at least 30 mm (fig. c, page 7) for the cooling
lines. To do this, use a circular cutter.
20
Explanation
DC fan
Thermostat button
Connection plug for DC fan
Thermostat
Connection cable
Explanation
Connection cable
Explanation
Connection cable
Explanation
Connection block
Compressor
Fan
Switch fig. i or TEC controller fig. j
Coldmachine
EN