Milestone ELPMBP06 Instrucciones De Instalación página 6

ELPMBP06
PREPARATION
NOTE:
The ELPMBP06 may either replace an existing
suspended ceiling tile, or it may be installed on top of
an existing suspended ceiling tile. Procedural
differences are called out as applicable.
1. Determine exact location of extension column (not included)
on suspended ceiling. Ensure column centerline falls within
8-1/2" radius of tile center point. (See Figure 1)
Be sure to consider the following items when determining
column location (See Figure 2):
• Dimensional offset of display/projector relative to
column (due to mount and/or interface).
• For Projectors: Any recommended dimensions of
projector relative to target (See installation instructions
included with the projector).
1
8-1/2"
(216mm)
Figure 1
Figure 2
6
2.
3.
4.
5.
6.
7.
2A
2B
8.
1
Mark location of column determined in Step 1 with pencil
(See Figure 1):
A. REPLACEMENT OF EXISTING TILE:
Mark location on ceiling tile framework (4 places).
B. INSTALLATION ON TOP OF EXISTING TILE:
Mark location on lower (finished) side of ceiling tile
(1 place).
Remove affected ceiling tile and any adjacent tiles required
for access.
If you are replacing an existing tile, proceed to Step 7.
Otherwise, continue below.
Press center tip of ceiling tile cutter (M) into finished side of
ceiling tile at marked location. Cut extension column hole
through tile using back and forth hand twisting motion.
Reinstall ceiling tile with extension column hole. Ensure tile
is oriented for proper location of hole.
Loosen seven clamp screws in lower (finished) side of
ELPMBP06 assembly (A). (See Figure 3)
Figure 3
Insert ELPMBP06 assembly (A) into suspended ceiling:
A. REPLACEMENT OF EXISTING TILE:
Lay directly on suspended ceiling framework.
B. INSTALLATION ON TOP OF EXISTING TILE:
Lay on top of suspended ceiling tile.
Installation Instructions
7
x 7
10