Kohler K-1665 Guia De Instalacion página 5

Plywood
Module
Ceiling
2. Installation - Module Style
Drill a 3-7/8" diameter hole (4" diameter if 3-7/8" hole saw is
unavailable) in the ceiling material at the proper spot.
Apply construction adhesive to the plywood attached to the light.
IMPORTANT! The light fixture should be as close to center of the
hole as possible. If the light fixture is too far off center, a gap may be
visible next to the trim ring.
Position the light on the shower module roof so the round carrier
receiver fits in the hole in the module ceiling.
Confirm that the light fixture is properly positioned while the
adhesive cures.
Connect the Wires
Remove the cover plate from the junction box.
Remove one small knockout slug from the junction box.
Pass 110 V, 60 Hz supply cable through the knockout hole and
secure with a strain relief bushing (not provided).
NOTE: Use UL listed wire nuts to connect the wires.
Connect the ground fixture (green) wire to the ground supply
line.
Connect the white wires to each other.
Connect the black wires to each other. Replace the cover plate.
Kohler Co.
Wire Nut
Cover
Plate
5
Junction
Box
1015878–2–B