Service And Repairs - Porter & Cable US58 Manual De Instrucciones

The depth that a fastener is driven is controlled by the pressure of the air
supply. The amount of pressure required will vary depending on the size of the
fastener being used and the material being fastened. Experiment with the air
pressure setting to determine the best pressure for the job at hand. Use only
enough pressure to drive the fastener heads on top of the workpiece (not into
the workpiece). Air pressure in excess of that required will cause premature
wear and/or damage to the tool.
CLEARING A J A M M E D
FASTENER
1 . CAUTION: Disconnect tool from
air supply.
2 . Turn tool upside down.
3 . Depress release latch and slide
magazine cover open.
4 . Remove the jammed fastener
(see Fig. 18).
5 . Close magazine cover.
CLEAN AND INSPECT DAILY
CAUTION: Disconnect tool from air supply before cleaning and
inspection. Correct all problems before placing the tool back in use.
W ipe tool clean and inspect for wear or damage. Use non-flammable cleaning
solutions to wipe exterior of tool only if necessary. DO NOT SOAK tool with
cleaning solutions. Such solutions can damage internal pa r ts .
Keep all screws tight. Loose screws can cause personal injury or damage tool.
I f t o o l i s u s e d w i t h o u t a n i n - l i n e o i l e r : p l a c e 1 o r 2 d r o ps of Porter-Cable A i r To o l
Oil into the air inlet of the tool at the beginning of each workday.
S E RVICE AND REPAIRS
All quality tools eventually require servicing or replacement of pa r ts due to
wear from normal use. Some user serviceable components are described in
t h e TROUBLESHOOTING Section. Complete product Service is available
from either an AUTHORIZED PORTER-CABLE SERVICE STATION or a
P O RTER-CABLE SERVICE CENTER. A l l r e pairs made by these agencies are
fully guaranteed against defective material and workmanship. We cannot
guarantee repairs made or attempted by anyone other than these agencies.
Should you have any questions about your tool, feel free to write us at any
time. In any communications, please give all information shown on the
nameplate of your tool (model number, type, serial number, e t c . ) .
Fig. 18
MAINTENANCE
7