Assembly Instructions - Dyna-Glo DG4WB Manual Del Usuario

ASSEMBLY INSTRUCTIONS

1
A X-Y-Z
2
X-Y-Z
AA
3
Y
X
Z
3-1 3-2
3-4 3-5
4
B
X-Y-Z
1. Measure the proper position where the spit rod (B) should be
placed. Make sure it won't interfere with the grill hood or any
E
B
part of the grill, then decide which holes on motor bracket
H
(X-Y-Z) and spit rod bracket (H) are appropriate holes to
F
attach to grill.
2. Use bolt (AA) to attach motor bracket (X-Y-Z) to the outside
of the grill's left side (or right, depending on the grill). Place
a washer (CC) on the end of each bolt (AA) and secure
D
G
assembly with nuts (BB).
NOTE: Do not overtighten. Attach spit rod bracket (H) to the
opposite side of the motor bracket (X-Y-Z) using the same
procedure.
CC BB
H
3. To accommodate different grills, the motor bracket (X-Y-Z) is
adjustable. If the motor bracket (X-Y-Z) as assembled does
not fit your grill, please adjust the piece: Use a Phillips
Y
screwdriver and pliers to loosen the screws on part Z of
Z
motor bracket (X-Y-Z). Decide where you want to mount the
motor on the grill and move part Z to the proper hole,
X
tightening the screws securely. If it still doesn't fit your grill,
remove Part Z from the bracket and mount the motor on Part
Y directly.
If adjusting the bracket as shown above still doesn't fit your
grill, loosen the 3 screws that hold together Part X and Part Y
(Fig 3-1). Turn Part X upside down and reassemble it to Part
Y, making the whole bracket a "U" shape as shown in Fig 3-1
3-3
through Fig 3-5. (Make sure to assemble the "U" shape
bracket in the correct method as shown in Fig 3-4 NOTICE).
Remember to place a washer before placing a nut. Secure
bolts with nuts. If it still doesn't fit your grill, remove Part Z
3-6
from the bracket and mount the motor on Part Y directly (Fig
3-6).
4. Some grills have a spit rod slot on the firebox and it is possible
that the spit rod bracket (H) might not fit your grill. In that case,
slide the collar (E) onto the spit rod (B). Let the collar (E) rest in
E the slot in the side of firebox.
H
NOTE: On some grills the spit rod (B) may not be long enough.
Attach the spit rod extender (I) and proceed with installation.
4-1
Hardware Used
Bolt
AA
Nut
BB
CC
Washer
B
5
I
x 4
x 4
x 4