Putting Into Operation - Hupfer OTA/47–36 Manual De Instrucciones

Chapter 4
Page 20
Step 2: Installation
Figure 7
Insert the appliance precisely into the worktop cut-out from above and fasten it.
If necessary, adjust the screw feet.
Put on the cladding.
4.3

Putting into Operation

Before the first use of the appliance, remove the protective plastic film from the metal plates.
INFO
Before putting the appliance into operation, it is necessary to check whether the appliance functions prop-
erly.
The following functions are to be checked separately:
In the mobile appliances: Function of the total brakes.
Before the appliance is put into operation it must be clean and dry.
Tray dispenser
OTA/47–36 | OTA/53–37 | OTA/58-33 | OTA/53–37 S | OTA/U-BW | OTA-E/BA-4xGN | TAG-1/53-37 | TA-2/53-37 | EBS-T/53-37
Transport, Putting into Operation, Assembly and Decommissioning
Assembly instructions EBS-T/53-37
Disposal of packing material
The packing consists of recyclable materials and can be disposed of appro-
priately. Thereby, the different materials are to be separated and disposed in
an environmentally compatible manner. In any case, the local bodies respon-
sible for disposal are to be involved for this purpose.
Putting into Operation
4330041_A0