Adjustment Of The Open Tray Dispensers; Adjust The Model Ota/S - Hupfer OTA/47–36 Manual De Instrucciones

Operation

Adjustment of the open tray dispensers

Hook or unhook adjustable springs uniformly in all groups of springs.
Preferably unhook the adjustable springs. Always leave the base springs inserted, if possible. Always
unhook the springs on the lower attachment bar.
Then reinsert the stacking platform using the grip holes. If the stacking platform is inserted correctly,
the guide rollers must face the interior of the appliance. Otherwise the crockery can become dirty.
Figure 9
NOTE
NOTE
5.2 Adjustment of the open tray dispensers
5.2.1

Adjust the model OTA/S

INFO
Figure 10
4330041_A0 OTA/47–36 | OTA/53–37 | OTA/58-33 | OTA/53–37 S | OTA/U-BW | OTA-E/BA-4xGN | TAG-1/53-37 | TA-2/53-37 | EBS-T/53-37
Grip holes on the stacking platform
Arrangement of the springs
A symmetrical arrangement of springs between the attachment bars is neces-
sary for guiding the stacking platform uniformly and without friction.
A slightly asymmetrical arrangement of springs within an attachment bar does
not pose any problem.
Maximum load-bearing capacity
Since all the tray dispensers are designed for a maximum load, the available
spring system of the appliances is entirely sufficient for all usual market
crockery items.
If the existing spring sets are insufficient, additional springs must be added.
Required tools
You need the following tools for the adjustment:
Open-end wrench SW 17,
Philipps screwdriver size 1,
Screwdriver size 7 (chisel width 0.24-0.28'' (6-7 mm) and thickness 0.03-0.04
''(0,8–1,0 mm))
Adjust tray guide rails
Chapter 5
Page 23
Tray dispenser