Hupfer OTA/47–36 Manual De Instrucciones página 62

Operation
Operation
5.4 Operation
Before the appliance is put into operation it must be clean and dry.
Before work starts, it is always necessary to check whether the tray dispenser is adjusted correctly for the
trays to be used.
The correct dispensing height must be ensured, so that the staff cannot suffer injury or become trapped.
Tray dispensers that are used for washing machines and conveyor systems must also be adjusted to the
dispensing height.
Loading the appliance
NOTE
NOTE
Insert the trays in small manageable stacks.
Remove trays
Remove the trays evenly
Moving the appliance
Release both total brakes.
Grip the appliance by the push bars and move it to the destination.
At the destination, apply both total brakes in order to secure the appliance against movement.
4330041_A0 OTA/47–36 | OTA/53–37 | OTA/58-33 | OTA/53–37 S | OTA/U-BW | OTA-E/BA-4xGN | TAG-1/53-37 | TA-2/53-37 | EBS-T/53-37
Maximum loading
The maximum filling of the tray dispenser is reached when the tip of the tray
stack is about 1.98'' (5 cm) above the top edge of the appliance.
Payload
Make sure that the tray dispenser does not exceed the permitted payload.
Chapter 5
Page 29
Tray dispenser