Before Use; Parts Identification - Panasonic ES8163 Instrucciones De Operación

10
d
f
c
e
b
g
6

Before use

This Wet/Dry shaver can be used for
wet shaving with shaving lather or for
dry shaving. You can use this water-
tight shaver in the shower and clean
it in water. The following is the sym-
bol of Wet shaver. The symbol means
that hand-held part may be used in
a bath or shower.
a
Treat yourself to wet lather shaves
for at least three weeks and notice
the difference. Your Panasonic Wet/
Dry shaver requires a little time to get
used to because your skin and beard
need about a month to adjust to any
new shaving method.

Parts identification

(see fig. 1)
A Protective cap
B System outer foil
C Inner blades
D System outer foil release buttons
E Pivot action selector
F LCD display
G On/Off switch
H Trimmer
I Trimmer handle
J Adaptor
K Power cord
L Charging stand
READ ALL INSTRUCTIONS BE-
FORE USE.
Charging
• When the adaptor is used for the
first time or if it has not been used
for six or more months, the plug
mark and backlight may not illumi-
nate for a few minutes after opera-
tion. These lights will eventually il-
luminate if kept connected.
The plug symbol blinks in the LCD dis-
play when the remaining battery ca-
pacity is 10% and less.
Connect the power cord to the
shaver, and plug the adaptor to an
AC outlet. (see fig. 1 (A))
The shaver will be adjusted automati-
cally to voltages between 100-240V
AC.
In some areas, a special plug adap-
tor may be required.
When the shaver is being charged, the
light in the LCD display turns on, and
the plug symbol appears (see fig. 2
(A)).
It shows the remaining battery capac-
ity from 0% to 100%, in 10% incre-
ments.
When the charging is completed, it will
indicate "100%" and the light in the
LCD display will flash (see fig. 2 (B)).
You can fully charge the shaver in 1
hour if the LCD display shows 10% and
lower.
Adequate ambient temperature for
charging is between 15 to 35 °C.
• If it is far below or over the appro-
priate temperature, the charging
time may extend, or the adaptor
may not function.
• In particular, low temperature may
7
6