Safety Cut-Out; Cleaning And Maintenance - Kalorik JK 46084 Manual De Instrucciones

SAFETY CUT-OUT

This cordless water kettle is protected with an automatic safety
•
device if accidentally switched on without water in the kettle.
If this happens, switch off the appliance by putting the switch in the
•
OFF position and wait about 10 minutes for the element to cool.
Then pour in enough cold water to cover the element. This will reset
the safety device.
The kettle may then be used as normal.

CLEANING AND MAINTENANCE

Before attempting any cleaning operation, make sure the
•
appliance is switched off, unplugged from the supply socket and
fully cooled down.
To clean the exterior surfaces, simply wipe over with a soft, damp
•
cloth and dry thoroughly.
Never use abrasive products, powders or scouring pads.
•
Under no circumstances shall the jug kettle or its power base be
•
immersed in water.
To remove mineral deposits from the water kettle, use products
(decalcifying solutions) made especially available for this purpose.
Make sure to use a type recommended for kettles or coffee makers.
Follow the guidelines as recommended by the manufacturer of the
de-calcifying solution. Rinse well.
FILTER
• Your appliance is provided with a mesh filter. This filter is factory pre-
installed before the spout.
• The filter is placed in front of the spout and should be rinsed clean
regularly.
• The filter can be removed by lifting it out of the guides.
• Use a soft brush and gently brush away the deposits of the filter.
• Replace it sliding it back into the guides.
• Please clean the filter on a regular basis, to avoid mineral deposit.
www.KALORIK.com
8
JK 46084 - 180330