Duramaxx 10028945 Manual De Instrucciones página 13

Batteries: The device requires 4 pcs good quality D cell Alkaline batteries for the best
•
result in operation. Do not mix old and new batteries together. After installing batteries
according to the polarity mold on the cabinet into the compartment, push the BAT-Check
button once and see if the Bat-Test LED lights up to verify the correct battery polarity.
• The WORK GROUP SWITCH serves the correct connotation of transmitters and receivers
(flashes), when several systems work at the same time in close proximity without being
meant to be associated together.
Leave the code in factory default, if this does not apply to you.
By setting different codes you can associate a group of systems (transmitters and flashes)
together - or respectively dissociate these from other systems.
• Mount the transmitter to the belt of a formerly installed outdoor camera and attach the
swan neck sensor to the flash of the camera with the help of the sensor holder.
You can use the shielding foil to cover any conventional visible IR (red glowing) flashes
(put a hole in it for the IR sensor in this case), or just attach it to any invisible IR flash.
camera with conventional flash (with visible red IR
glow), covered with shielding foil
The BLACKFLASH is waterproof and it is a temporarily mountable device. Therefore it may be
mounted to trees and dismounted without doing any harm to nature. Please leave no traces
and install the device only in harmony with local laws and regulations.
Preparation
camera model with invisible IR flash - no covering
needed
13