Safety Instructions; Functional Overview; Technical Data - ANSMANN IL 300R Operación Manual

OPERATION MANUAL: IL300R

SAFETY INSTRUCTIONS

ƒ Read the operating instructions carefully before using and observe the safety notices!
ƒ
Do not use the device if there is damage to the housing, plugs or cable. Consult your
ƒ ƒ
local authorized specialist!
ƒ The device must only be operated in enclosed, dry rooms!
ƒ
ƒ Carry out cleaning tasks only when the mains plug is removed from the mains power!
ƒ
ƒ Do not attempt to open the device! Repair work and replacing the rechargeable battery
ƒ
pack may only be carried out by an authorized specialist!
Keep away from children! Children should be supervised in order to ensure that they do
ƒ ƒ
not play with the device!
This device is not to be used by persons (including children) who have restricted
ƒ ƒ
physical, sensory or mental capabilities or who do not have adequate experience and
knowledge in handling this kind of device. Such persons must be instructed before-
hand by an appropriate person who is responsible for their safety or must be super-
vised during their use of the device!
ƒ Failure to observe the safety instructions can result in bad injuries to persons, proper-
ƒ
ty or damage to the device!

FUNCTIONAL OVERVIEW

ƒ Professional work light with the latest SMD LED technology
ƒ
ƒ Small additional spotlight at lamp head
ƒ
ƒ Robust plastic housing with rubber-coated grip
ƒ
ƒ 180° rotatable lamp handle in 8 steps for flexible lighting alignment
ƒ
ƒ Two foldable and 360° rotatable hooks at the back
ƒ
ƒ Two magnets at the back of the housing and one magnet at the bottom of the handle
ƒ
ƒ Impact protected Li-Ion battery pack (3.7V / 2200mAh)
ƒ
ƒ Charging via USB power supply (5V / 1000mA) or car adapter
ƒ
ƒ Charge control indication via coloured LEDs
ƒ

TECHNICAL DATA

Integrated LED's:
Illumination:
Luminous flux:
Lighting time:
Input external power supply:
Input car adapter:
Charging time:
OPERATION
The on/off switch for the work light can be found on the front of the housing:
ƒ Press 1x: The additional spotlight will be switched on.
ƒ
ƒ Press 2x: The additional spotlight will be switched off.
ƒ
ƒ Press 3x: The main light will be switched on.
ƒ
ƒ Press 4x: The main light will be switched off.
ƒ
CHARGING PROCEDURE
Charge the workshop lamp fully before using for the first time. If the work lamp has been
stored for an extended period of time it should also be fully charged again before first
use.
Deutsch |
Main light: 6x 0,5W SMD-LED
Additional spotlight: 1W LED
555 Lux / 1m distance
325 Lumen
ca. 3,5h (main light), or ca. 9h (additional spotlight)
100-240V AC
12V-24V DC
ca. 3h
English
| Français | Español | Português | Nederlands