General Safety Rules - Torin BIG RED TR6453 Manual Del Propietário

GENERAL SAFETY RULES

WARNING: Read and understand all instructions. Failure to follow all instructions listed below may
result in serious injury.
CAUTION: Do not allow persons to operate or assemble this product until they have read this
manual and have developed a thorough understanding of how the product works.
WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions or situations that could occur. It must be understood by the operator
that common sense and caution are factors that cannot be built into this product, but must be supplied by
the operator.
USE AND CARE
Make certain that the operator thoroughly understands the inherent dangers associated with the use and
misuse of the product. If any doubt exists as to the safe and proper use of this product, remove from service
immediately.
• Do not modify the product in any way. Unauthorized modification may impair the function and/or safety and
could affect the life of the equipment.
• Always check of damaged or worn out parts before using the product. Broken parts will affect the
product operation. Replace or repair damaged or worn parts immediately.
• Store idle. When the product is not in use, store it in a secure place out of the reach of children. Inspect it
for good working condition prior to storage and before re-use.
• Not for use by children or people with reduced mental capacity.
• Do not use under the influence of drugs or alcohol.
• Ensure children and other bystanders are kept at a safe distance when using product.
• Instructions and safety information shall be conveyed in the operator's native language before use of this
product is authorized.
NOTE: Any creeper that appears damaged in any way, or operates abnormally shall be removed from service
immediately. If the creeper has been subjected to a shock load (a load dropped suddenly, unexpectedly
upon it), immediately discontinue use until repairs have been completed. It is recommended that
weekly inspection be completed to check that product is in good working condition.
INSPECTION
• Inspect the product carefully before each use. Ensure the product is not damaged, excessively worn, or
missing parts.
• Do not use the product unless it is properly lubricated.
• Using a product that is not in good clean working condition or properly lubricated may cause serious injury.
• Inspect the work area before each use. Make sure it is free and clear of any potential hazards.
GENERAL SAFETY RULES
IMPORTANT SAFETY CONSIDERATIONS
3