Detailed view of the BT-Rider
Main unit
Buttons
The buttons on the communication units lets you enable Bluetooth
connection and telephone functions They can be activated in two
different modes:
•
Short pressure: push the button less than one second
•
Longer pressure: push the button for more than 3 seconds
center CTRL button
Volume -
Charging socket
Fixing plate with microphone and speaker
Charging batteries
Make sure that both units are fully charged prior to initial use. Allow at
side Function key
least 4-5 hours for a full charge before using for the fi rst time. Normally
for call reject, call ter-
3-4 hours will suffi ce for complete charge.
mination and redial
Charge the unit by inserting the wall-charger into the charging socket
(lift the rubber cover to insert the plug).
Volume +
•
•
2
Microphone
back-plate of the clamp (press on
arc to release the headset unit)
Sliding-plate of the clamp
The red LED on the BT-Rider will turn on when charging begins.
Allow the headset to charge until the red LED turns off.
When the charge is complete, release the headset from the
charger.
Earphone