Hergom CRETA Instrucciones Para Instalación, Uso Y Mantenimiento página 39

Tube support
OPTION A
Put the tube support in
place from below using
screws going through
the wrought iron work
or the structural ceiling
STEPS FOR PUTTING THE LOWER AND
TELESCOPIC TUBES IN PLACE
Slide the inside tube
through the mouth of
the supporting piece
to the approx.
indicated height
MODEL CRETE –HANGING VERSION
FASTEN THE TUBE SUPPORT
1
Tidy up the hole in the ceiling where the chinmey goes.
Select option A or B to fasten the tube support to the ceiling.
Nut and washer
Heat resistent join
Screw going through the
wrought inron work or the
structural ceiling
Inside hole
Outside hole
1
NOTE:
The holes drilled outside the tube support have to
fasten it to the wrought iron work or the ceiling as
they have the structural job of supporting the stove.
The inside holes must be made in the lower part of
the ceiling as they only support the telescopic tube
and have no structural function. If the tube support
is put in place in the upper part of the ceiling the
holes to fasten the telescopic tube are made using
the remaining piece as a guide.
2
Fasten the inside tube to the upper
piece of the ceiling using the
capscrews. Seal the join with heat
resistant putty
39
OPTION B
Put the tube support in place
from above using screws going
through the wrought iron work
or the structural ceiling
Sealing capscrews.
Make a mark using
the capsrew itself,
remove and drill a
small hole
Sealing capscrews
M6x12
DIN914
Capscrews
M6x12
DIN914