Water Dispenser; Ice Maker - IKEA WRF560SEHZ Instrucciones Para La Instalación

Door Open Alarm
The Door Open icon lights up when a door has been open
■
for 5 minutes and cooling is on. An alert tone will sound
three times, and the Door Open icon will flash seven times.
This pattern will repeat every 2 minutes until all the doors are
closed completely. The feature then resets and will reactivate
when a door is left open again for 5 minutes.
NOTES:
To mute the audible alarm while keeping the doors open
■
such as while cleaning the inside of the refrigerator, press
any button on the control panel. The alarm sound will be
temporarily turned off, but the Door Open icon will still be
displayed on the dispenser control panel.
All doors must be completely closed to turn off the Door
■
Open icon.
Sabbath Mode
Sabbath mode is designed for those whose religious
observances require turning off the lights.
In Sabbath mode the temperature set points remain unchanged,
but the interior and dispenser lights turn off, all sounds and
alarms are disabled and the dispenser screen backlight turns off.
To turn on Sabbath mode, press and hold both FREEZER
■
TEMP and FRIDGE TEMP at the same time for 3 seconds.
After 3 seconds, an "engage" tone will sound and the icons
on the control panel display will flash and then disappear.
NOTE: You must close the doors to turn off the lights. The
lights will remain off while the refrigerator is in Sabbath mode.
To turn off Sabbath mode, press and hold both FREEZER
■
TEMP and FRIDGE TEMP at the same time for 3 seconds.
After 3 seconds, an "disengage" tone will sound and the
control panel will display the normal screen.
NOTE: After turning off Sabbath mode, you must first close
the doors to turn ON the lights. Then the lights will function
normally.
NOTES:
Sabbath mode does not disable the water dispenser or the
■
ice maker. To turn off the ice maker, see "Ice Maker."
If a power failure occurs or you unplug the refrigerator while
■
it is in Sabbath mode, it will take 10 minutes for the cooling
system to resume when power is restored.
Water Filter Status Light and Reset
The filter reset control allows you to restart the water filter status
tracking feature each time you replace the water filter. See
"Water Filtration System."
Press and hold WATER FILTER for 3 seconds, to reset the
■
water filter status to Good. The Water Filter icon will turn
blue.
Air Filter Status Light and Reset
The filter reset control allows you to restart the air filter status
tracking feature each time you replace the air filter. See "Install
Air Filter."
Press and hold AIR FILTER for 3 seconds, to reset the air
■
filter status to Good. The Air Filter icon will turn blue.

Water Dispenser

IMPORTANT:
Allow 3 hours for the refrigerator to cool down and chill water.
■
Allow 24 hours to produce the first batch of ice. Discard the
■
first three batches of ice produced.
Flush the Water System
Air in the water dispensing system can cause the water
dispenser to drip. After connecting the refrigerator to a water
source or replacing the water filter, flush the water system.
Flushing the water dispensing system, forces air from the water
line and filter and prepares the water filter for use. Additional
flushing may be required in some households.
14
NOTE: As air is cleared from the system, water may spurt out of
the dispenser.
1. Using a sturdy container, depress and hold the water
dispenser paddle for 5 seconds.
2. Release the dispenser paddle for 5 seconds. Repeat steps 1
and 2 until water begins to flow.
3. Once water begins to flow, continue depressing and releasing
the dispenser pad (5 seconds on, 5 seconds off) until a total
of 4 gal. (15 L) has been dispensed.
Dispense Water
1. Hold a container under the dispenser spout while pressing
the dispenser pad.
2. Release the dispenser pad to stop dispensing.

Ice Maker

IMPORTANT: For models with a water filter, after connecting the
refrigerator to a water source or replacing the water filter, fill and
discard three full containers of ice to prepare the water filter for
use.
Turning the Ice Maker On/Off
To turn the ice maker ON, simply lower the wire shutoff arm.
To manually turn the ice maker OFF, lift the wire shutoff arm to
the OFF (arm up) position and listen for the click.
NOTE: Your ice maker has an automatic shutoff. As ice is made,
the ice cubes will fill the ice storage bin and the ice cubes will
raise the wire shutoff arm to the OFF (arm up) position. Do not
force the wire shutoff arm up or down.
Ice Storage Bin
1. Wash the ice storage bin with mild soap and warm water.
2. Slide the ice storage bin under the ice maker, and push it
toward the back as far as it will go.
3. Lower the arm on the ice maker to the "ON" position.
NOTE: It usually takes approximately 24 hours for the ice
maker to begin producing ice. You may notice the ice has
an "off-taste." If so, discard the first three batches of ice
produced. After that the "off-taste" should be gone.
Ice Production Rate
The ice maker should produce approximately 8 to 12 batches
■
of ice in a 24-hour period. Allow 3 days to completely fill the
ice container.
To increase ice production, lower the freezer and refrigerator
■
temperature. See "Using the Control(s)." Wait 24 hours
between adjustments.