Dust Extraction - Festool ETS 125 REQ Manual Del Usuario

English
8.1 Electronics
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
Constant speed
The preselected motor speed is kept constant
through electronic control. This means that, if
the machine is used as intended (reasonable
contact pressure), a constant sanding speed is
achieved.
Setting and adjusting the speed
The speed can be set [1-3] between 6000 and
12000 min using the adjusting wheel.
-1
This enables you to optimise the sanding speed
to suit the material (see chapter "Working with
the machine").
8.2 Replacing the sanding pad [3]
An optimal work result can only be ach­
ieved using original accessories and con­
sumables. The use of non-original accessories
or consumables invalidates the right to claim
under warranty.
Warning! Do not perform any structural
changes in the open interior space of the
machine when the sanding pad is dismantled.
Undo the four screws.
Remove the sanding pad by pulling it down­
wards.
Attach the new sanding pad.
Use four screws to tighten it by hand
(2.5 Nm).
10
Hardness of the sanding pad
Adapted to the surface being processed, the
machine can be equipped with sanding pads of
different hardnesses.
Soft: Universal for coarse and fine sanding, for
flat and convex surfaces.
Extra-soft: Fine sanding of moulded parts,
arches, radii. Do not use on edges.
8.3 Attaching sanding accessories using
StickFix [4]
The suitable StickFix sandpaper and StickFix
sanding cloth can be attached quickly and sim­
ply to the StickFix sanding pad.
► Press the self-adhesive sanding accessory
onto the sanding pad [1-5].
In the case of a weakening adhesive ef­
fect of the StickFix surface, the sanding
pad accessories, in particular those which are
not yet touching the workpiece, may come
loose from the sanding pad and cause injuries.
Replace the sanding pad!
3
8.4

Dust extraction

Dust hazard
► Dust can be hazardous to health. Always
work with a dust extractor.
► Always read applicable national regula­
tions before extracting hazardous dust.
Integral dust extractor with long-life dust bag
As standard, the sanders are equipped with an
integral dust extractor. The sanding dust is ex­
WARNING
4