Extremis Sticks Manual Del Usuario página 14

sticks
contents
STICKS INDOOR
1 x base 60 x 30 cm
or 50 x 25 cm
1 x fibreglass rods
1 x felt protection pad (for the rubber
base)
contents
STICKS OUTDOOR
1 x base 60 x 30 cm
1 x fibreglass rods
assembly
° Insert the rods in the holes in the base.
FOR THE RUBBER BASE
° the side with the Extremis logo should be
facing upwards.
° when you install the rods for the first time,
push them through the thin layer of rubber
inside the holes.
° when you disassemble the Sticks space
divider, bundle the rods with the same side
up or down, as the base sometimes leaves
marks on the rods.
° when re-inserting the rods in the base,
make sure they are facing the same way as
they did before the disassembly.
useful advice
° Wooden bases: always horizontally align
the bases before fitting the rods. To this end
adjust the base's rubber feet.
° To create a special effect, you can mix
differently coloured rods or create smooth
colour transitions.
° You do not have to insert all the rods. If
you want more transparency, just use less
rods.
maintenance
° The rubber and the fibreglass rods do
not require special maintenance. They can
simply be kept dustfree with a slightly damp
cloth.
° The base in solid wood has been treated
with wood oil. If so desired, you can repeat
this treatment after a while.
www.extremis.be
attention!
° During the production process
tiny glass fibres may come loose
and remain stuck to the rods. In
case of skin contact they may cause
slight irritation. We consequently
recommend that you thoroughly
dust or rinse the rods before
inserting them into the bases to
reduce these fibres to a minimum.
° Only the rubber base and the
fibreglass rods are perfectly suited
for outdoor use.
° If Sticks is exposed to strong
winds, it might be necessary
to fix its base to the ground.
° Do not allow anyone to use the
rods for playing or jousting. They
may cause injuries.
° If you intend to put the rubber
base on a delicate surface, we
recommend that you use the felt
protection pad.
° Do not touch the fibreglass rods
with your bare hands. Always use
a glove to assemble Sticks.
° Because of the specific
characteristics of the production
process of glass fibre, colours
can only be reproduced
approximatively and colour
differences may occur. This is the
case for both standard colours as
for colours upon request.