Extremis Sticks Manual Del Usuario página 16

sticks
sticks enlightened
REGULAR & CURVED
DECLARATION OF CONFORMITY: DECLARATION OF CONFORMITY:
This product meets the This product meets the
requirements of European requirements of European
Directives 2006/95/EC and 2004/108/EC. Directives 2006/95/EC and 2004/108/EC.
Specifications Specifications
° model: SB6030HDL ° model: SB6030HDL
° 100-240 V ~ 50/60 Hz ° 100-240 V ~ 50/60 Hz
° max. 20 x 2.4 W ° max. 20 x 2.4 W
° type of light bulb: 2 x LED light bulb ° type of light bulb: 2 x LED light bulb
Sticks Sticks
° IP 20 – DO NOT INSTALL ° IP 20 – DO NOT INSTALL
OUTDOORS OR IN HIGH-HUMIDITY OUTDOORS OR IN HIGH-HUMIDITY
AREAS – AVOID ALL CONTACT WITH AREAS – AVOID ALL CONTACT WITH
WATER. WATER.
The supplied plug (part of SLS) is a The supplied plug (part of SLS) is a
Europlug (Type C CEE 7/16). It can be Europlug (Type C CEE 7/16). It can be
used throughout Europe, except in the used throughout Europe, except in the
United Kingdom, Ireland and Malta. United Kingdom, Ireland and Malta.
The assembly and the replacement of the The assembly and the replacement of the
LED light bulbs may only be carried out LED light bulbs may only be carried out
by a qualified electrician. Extremis shall by a qualified electrician. Extremis shall
not be liable in any way for any damage not be liable in any way for any damage
caused by incorrect assembly, improper or caused by incorrect assembly, improper or
unforeseeable use, taking account of all the unforeseeable use, taking account of all the
specifications and instructions contained in specifications and instructions contained in
this manual. this manual.
CONTENTS
° base x ... (1-20 pieces): LED illuminated
regular or curved base, fully assembled
° SLS x 1: cable with foot-operated switch
and plug
° rods x ... (1-20 sets): fibreglass rods
assembly
By each time connecting the base's fitted cable to the following base you can make a row of
up to 20 Sticks Enlightened bases. The last base's cable must then be replaced by the cable
with the foot-operated switch and plug (SLS). These operations may only be carried out be
a qualified electrician.
1. Turn over all the bases except the first one
in the row (the holes for the rods should be
facing downwards) and unscrew the grey
covering plates. Also unscrew the cable
clamps.
2. Connect the first base's cable to the
second base, the second base's cable to the
third base and so on. To this end, insert
the + and - cable ends into the appropriate
openings. Create the openings by pushing
the little buttons on the topside of this
module.
www.extremis.be