Extremis Sticks Manual Del Usuario página 17

sticks enlightened
REGULAR / CURVED
REPLACING A LED LIGHT BULB
The following operations may only be
carried out by a qualified electrician.
A. Make sure that all the bases are
disconnected from the electricity network!
B. Turn over the base and unscrew the
covering plate. Remove the staples holding
the cables in place. Disconnect the red and
black cable of the faulty LED light bulb at
the black coupling module by gently pulling
the little white blocks.
3. Take the last base in the row and replace
the fitted cable by the cable with the
foot-operated switch and plug. Always
insert two identically coloured cables in
each module (blue and blue / brown and
brown).
C. Remove the faulty light bulb from the
topside of the base, if necessary by pushing
from below. Insert a new EXTREMIS LED
light bulb and put the cables into the cable
channels. Keep them in place with a few
staples.
D. Connect the cables at the coupling
module by gently pushing them in. Screw
the covering plate onto the base and turn
over your Sticks.
4. Screw the cable clamp(s) down again.
Make sure that both cables are lying next
to each other and not on top of each other.
Now also screw the covering plate(s) onto
the base.
5. Turn over the bases and put them at the
desired spot. If necessary, use the adjustable
feet to level the bases. Test the lighting
before inserting the rods.
english