Tools Required - Whittier Wood Furniture 114Wa Instrucciones De Ensamblaje

Phillips Head Screwdriver, Adjustable or 9/16" Wrench, Tape Measure, Wood Glue
IMPORTANT NOTE: Apply fnish to this unit before the final assembly.
H
I
Fig. 1
1. Place the table face-down on a clean, protected surface. The two dowel holes in the back legs
must face to the front, and the dowel holes in the front legs must face toward the back. Loosely
attach the Left and Right Legs (H and I) to the top assembly by inserting 3/8"x2½" Hex Bolts (V)
with Washers (W) through the Leg Brackets (Y) and into the inserts in the Legs (H and I). See
Figures 1 and 1a. Place the Top/leg assembly on its side. Spread a thin layer of glue in the dowel
holes in each leg. Slide the rack assembly between the legs and gently tap into place. Quickly wipe
away any excess glue. See Figure 1b. Turn the table face-down and tighten the hex bolts in the legs.
Page 4 — 114Wa — Rev. 11/09
114Wa Chef's Dropleaf Island
Assembly Instructions

Tools Required:

Prior to doing so, read the enclosed finishing hints.
Fig. 1a
H
Y
I
A
Fig. 1b
I
J
H
K
I