Look R96 Manual De Montaje página 16

FittinG and adJustinG
tHe saddLe
1. Fit the saddle by positioning the rails
between the two parts of the carriage.
2. Gently tighten the clamping screw.
3. Adjust the direction of the saddle as
follows:
- To tip the saddle forwards: unscrew
the clamping screw and tighten the front
nut with a 8 mm flat spanner.
- To tip the saddle backwards: unscrew
the front screw and then tighten the
clamping screw.
4. Adjust the position of the saddle.
5. Tighten the screws of the back of the
seat post to 6 Nm.
caution: to ensure that the Loctite holds
well, wait 2 hours before using the system.
3
2
1
1. Right cone
2. FHCX M5x30mm screws
3. Fork head
4. M6x10 extractor screw
5. FHCX M5x30mm screws
6. Left cone
FittinG tHe steM
on tHe ForK
1. Degrease the cones (1 & 6), the fork
head (3) and the stem arm with a dry
cloth.
2. Grease the M6 x 10 mm extraction screw (4).
3. Screw in and hand tighten the M6 x 10
mm screw in the left cone. The screw
head should bear against the small
diameter of the cone (Fig. 5).
steM
4
5
6
7
8
11 10
7. Stem
8. FHC M5x30 mm screws
9. Arch
10. Stem cover
11. Cover barrel
EN
Fig. 4
9
17