General Electric IM-6D Instrucciones Para Instalación página 24

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS Q
of the refrigerator—
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
To reduce the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
REMOVE THE COVER
1
to remove the compressor compartment access
attach the cover to the back of the refrigerator
case.
Be sure to save the screws as the access cover
must be reinstalled later to ensure your refrigerator
will function properly.
WARNING
To reduce the risk of death or
electric shock, you must follow these
instructions:
Unplug the refrigerator before removing any
panels.
Do not damage any wiring while the panel is
removed.
Replace all parts and panels before plugging
the refrigerator back in.
24
Installation Instructions
L M N Q R S T U V
Pliers Sharp knife
or W
ATTACH THE WATER VALVE
2
Locate the female
connector plug
female
connector
male terminals on the
water valve
wire can go on either
terminal.
Fasten the water valve to the cabinet edge hole
with the hex-head screw
of the water valve to be sure it is hand tight.
DO NOT USE TOOLS.
INSTALL WATER LINE CLAMP
4
WARNING
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
Attach the metal water line clamp
the kit through the clamp
the back of the cabinet.
be used for the tubing from the water valve up to
the icemaker.
C
15
ELECTRIC SHOCK
HAZARD
screw
7
17
4
49-60704-2