Attaching The Brush Head; Charging Your Sonicare; Deluxe Recharge Gauge - Philips Sonicare FlexCare HX6911/02 Manual De Instrucciones

ENGLISH
10
2 Slip one edge of the new ring over the bottom
of the brush head. Then press down on the
other side to snap the ring in place.

Attaching the brush head

1 Align the brush head so the bristles face the
front of the handle.
2 Firmly press the brush head down on the metal
shaft until it stops.
Note: There is a small gap between the colour code
ring and the handle.

Charging your Sonicare

1 Plug the charger or sanitiser into a wall socket.
2 Place the handle on the charger or sanitiser.
, The flashing light on the battery gauge indicates
that the toothbrush is charging.

Deluxe recharge gauge:

Indicates the amount of charge left in the battery
- 3 green LEDs: 75-100%
- 2 green LEDs: 50-74%
- 1 green LED: 25-49%
- 1 flashing yellow LED: less than 25%
Note: If the battery charge of your Sonicare is low,
you hear 3 beeps and 1 LED on the recharge gauge
flashes yellow for 30 seconds.
Note: To keep the battery fully charged, we recommend that
you keep your Sonicare on the charger or sanitiser when not
in use. It takes at least 24 hours to charge the battery fully.