Thompson ROCZ107 Manual Del Usuario página 7

Note
• Do not move the remote controls during the
learning procedure.
• Ensure that the room is not lit by uorescents
tubes or low energy consumption lamps since
such light sources could interfere with the
copying.
• The 2 remote controls must be at least
1 meter away from any light source.
• During learning mode, if no key is selected for
more than 30 seconds, the learning mode will
exit automatically or
if no other remote signal is received.
• Each function key will hold only one
command. A new command to be learned will
automatically replace the previous one.
• It is not possible to learn any new functions to
the TV and STB key.
7.2 ENTER LEARN MODE
1. To teach a new function to the remote control,
press the device selection button for the
relevant device (TV or STB).
2. Press and hold the [MUTE] and [VOL+] keys for
approx. 3 seconds until the LED will be lit.
3. The Universal Remote Control is now ready to
learn new commands.
7.3 LEARNING OF KEYS
1. Press and release the desired key on the
original remote control which you want the
command to be learned. The LED at your
Universal Remote Control will ash to con rm
that the information has been received.
2. Then press and release the target key on the
Universal Remote Control you want learned.
3. If the LED ashes 3 times and then remain on,
the command has been learned successfully.
4. Repeat these steps to learn other key functions.
5. Press the TV or STB button to save all learnt
functions and to exit the learning mode.
Note
While replacing the batteries, the remote control will
keep the functions of the learned keys.
7.4 CLEARING OF LEARNED KEYS
7.4.1 CLEARING OF ONE LEARNED KEY
1. Press and hold [MUTE] and [VOL-] keys for
3 seconds until the LED will be lit.
2. Press and release the desired key at the
Universal Remote Control which you want to
clear the learned command. If the LED ashes
3 times, the learned command has been
cleared successfully.
7.4.2 CLEARING OF ALL LEARNED KEYS
1. Press and hold the [MUTE] and [POWER] keys
for approx. 6s until the LED indicator ash four
times, then means the command has been
cleared successfully.
8. Maintenance
• Do not mix new and used batteries for
powering the Universal Remote Control, as old
batteries tend to leak and may cause power
drain.
• Do not use corrosive or abrasive cleaners on
your Universal Remote Control.
• Keep the Universal Remote Control dust free by
wiping it with a soft, dry cloth.
9. Troubleshooting
Q. My Universal Remote Control does not work at all!
A. Check your TV/STB device. If the device's main
switch is turned off, your URC cannot operate your
device.
A. Check whether your batteries are inserted properly
and are in the correct +/- position.
5