Overhead Rigging - Briteq BT-Strobe 3000 Manual De Instrucciones

ENGLISH

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
HOW TO SETUP:
MAIN MENU:
 To select any of the menu options, press the MENU button up to when
the required option is shown on the display.
 Select the function with the ENTER button. The display will blink.
 Use DOWN and UP button to choose the desired menu option.
 Once the required menu option is selected, press the ENTER button to
select.
Remark: Press the MENU button for about 2 seconds to return to running
mode or just wait 8 seconds.
DMX512 Address Setting
Used to set the start address in a DMX setup
 Press the MENU button until
 Press the ENTER button to select.
 Use DOWN and UP buttons to change the DMX512 address.
 Once the correct address is shown on the display, press the ENTER
button to confirm.
 Press the MENU button for about 2 seconds to return to running mode.
Channel Mode
The unit has 4 different channel modes + settings for use with the BT-
STR4 4channel remote. Refer to the DMX-chart to see the differences.
 Press the MENU button until
 Press the ENTER button to select.
 Use DOWN and UP button to select one of the available channel modes.
 Once the mode is selected, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to return to running mode.
Output Power
Used to select the output power of the strobe, can be used to avoid overload of the power line.
 Press the MENU button until
 Press the ENTER button to select.
BRITEQ
®
is shown on the display.
is shown on the display.
is shown on the display.
4/42
USER MANUAL
BT-STROBE 3000