Frequently Asked Question - FM RX203 Manual De Instruccion E Instalacion

Change door opening. (Only RXL series)
The ovens with an open side door, you can change the opening direction of the same, for this operation
please fallows the next steps:
1. Remove the head screws, which are holding the hinges.
2. Once subtracted the hinges, insert the screws in the same holes.
3. Rotate the door 180⁰ and place along with the hinges on the new position.
Note: Do not fully tighten the hinge screws until you have properly not adjusted the door in position.

12. FREQUENTLY ASKED QUESTION

When you finish the work with the device disconnect from the network, wait for cooling during 30 minutes
and clean the chamber and trays with soap and water.
DO NOT USE water directly at the device; it can cause damage in the components
Below is a list of causes / failures / and solutions.
FAILURE
The device not start
The device is not
cooking properly
The chamber lights
are not turn on
Steam leaves when
the door is closed
CAUSE
Lack of voltage
Inadequate network connection
Thermostat not working
Timer not working
Safety switch not working
Safety thermostat intervenes
(except RX404,RX304, RX424)
Fan not working
Element not working
Grill not working
Humidifier not working
Relay not working
Turning inverse not working
(except RX404, RX304,RX424,
RX484)
Thermostat not working
Timer not working
The lamp is not tight
Lamp melted
Misplacement of the door gaskets
Misaligned door closes
SOLUTION
Check voltage
Verify network connection
Consult with the technician
Consult with the technician
Consult with the technician
Reset the thermostat at the front. If
the problem persist consult with the
technician
Consult with the technician
Consult with the technician
Consult with the technician
Consult with the technician
Consult with the technician
Consult with the technician
Consult with the technician
Consult with the technician
Tight the lamp
Change the lamp
Place it well. If the problem persist
consult with the technician
Consult with the technician
39