Motor Maintenance; Care & Cleaning; Care And Maintenance - Muskoka EST-425T-10 Guía De Uso Y Cuidado

Maintenance
GLASS INFORMATION
1. Under no circumstances should this product be operated with broken glass.
2. Do not strike or slam the glass.
3. Do not use abrasive cleaners to clean the glass.
4. This product uses tempered glass. Replacement of the glass supplied by the manufacturer should be done
by a qualified service person.
LIGHT BULB INSPECTION AND REPLACEMENT
The flame effect is created by two 40-Watt light bulbs with an E-12 (small) socket base. Use only this type of light
bulb. If the flame effect does not work, the bulbs may have come loose or been damaged during shipping.
CAUTION: Light bulbs become very hot during use. Allow at least 10 minutes for the bulbs to cool
before touching.
To inspect or replace the bulbs, first unplug the power cord from the outlet. Locate the access panel on the back
of the stove. Remove the screws and the panel. Check the bulbs to be sure they are finger tight and in working
order. Replace any damaged or faulty bulbs. Reattach the access panel. Do not operate this heater without the
access panel in place. Do not remove the back cover of this heater. There are no serviceable parts inside.
WARNING: Do not exceed 40 watts per bulb. Use of higher rated bulbs may result in a fire, causing
property damage or personal injury.

MOTOR MAINTENANCE

Always disconnect the appliance from the main power supply and allow it to cool before any servicing operation.
The motors used on the fan heater and flame blower are pre-lubricated for extended bearing life and require no further lubrication. Howev-
er, periodic cleaning/vacuuming of the appliance around the air intake and exhaust, as well as the fan heater is recommended. For heavy
or continuous use, periodic cleaning must be done more frequently. If the heater blows alternating cold and warm air, check the fan for free
movement and for debris restricting air flow. If the fan does not move freely, the unit must be turned off and the fan replaced immediately in
order to prevent further damage to the unit.
Care & Cleaning
Always turn the stove OFF and unplug the power cord from the outlet before cleaning. Use a vacuum or duster
to remove dust and dirt from the heater and vent areas. To maintain the finish, clean with a soft, slightly damp
cloth and buff with a dry cloth. Never use abrasive cleansers, liquid sprays, or any cleaner that could scratch
the surface.
10