Light Kit Assembly (Optional); Important - Craftmade PUH52 Guia De Instalacion

11. Light Kit Assembly (Optional).

WARNING: Failure to disconnect power supply at
main panel prior to light kit assembly may result in
serious injury.
IF YOU WISH TO USE YOUR FAN WITH A LIGHT KIT
(sold separately), remove 3 screws from switch
housing and then remove switch housing cap from
switch housing. (Refer to diagram a.)
Locate BLUE (or BLACK) and WHITE wires in the
switch housing labeled FOR LIGHT. Remove and
discard plastic that holds these 2 wires together.
(Refer to diagram a.)
If your light kit is to be mounted directly to switch
housing, remove 3 screws from light kit fitter (refer
to diagram b). Make wire connections as described
below.
If your light kit is to be attached by a threaded rod
(refer to diagram c), remove hex nut and lock
washer from threaded rod on light kit fitter. Punch
center cap out of switch housing cap with a
screwdriver. Push wires from light kit fitter (one by
one) through hole in middle of switch housing cap
and screw switch housing cap onto threaded rod
followed by lock washer and hex nut that were
previously removed. Tighten hex nut over lock
washer for a secure fit. Make wire connections as
described below.
Connect WHITE wire from light kit fitter to WHITE
wire from switch housing. Connect BLACK wire
from light kit fitter to BLUE (or BLACK) wire from
switch housing. Be sure molex connections snap
together securely. Align holes in switch housing
cap with holes in switch housing. Re-insert 3
screws that were previously removed and securely
tighten all 3 screws.
Attach glass shade(s) to light kit fitter using the
hardware provided with the light kit. (Refer to
diagram d.)
NOTE: If you are installing a bowl fixture, the
bulb(s) must be installed first.
Install bulb(s) specified by the light kit. (Refer to
diagram d.) If you are installing a halogen bulb, be
sure not to handle glass directly with your fingers as
oil from the skin may shorten the life of the bulb.
IMPORTANT: When changing bulb(s), remember
to allow bulb(s) and glass shade(s) to cool before
touching.
blue (or
black) wire
diagram a
diagram b
hex nut
lock washer
diagram c
diagram d
bulb
[representative only]
page 7
motor housing
switch housing
white wire
molex connections
switch housing cap
light kit fitter
[representative only
for directly connecting
light kit]
switch housing cap
center cap
switch housing cap
light kit fitter
[representative only
for using threaded
rod to attach light kit]
light kit
fitter
[representative only]
glass shade
[representative only]