Festo CMMS-ST-C8-7-G2 Manual Del Usario página 17

1 User
Intended use
The CMMS−ST−...−G2 stepping motor controller is a fully
digital servo positioning controller for activating two−phase
hybrid stepping motors with a maximum current of up to 8
A, in particular the Festo MTR−ST and EMMS−ST series.
The master controller (PLC/IPC) is connected via one of the
following controller interfaces:
Digital inputs/outputs
PROFIBUS−DP
CANopen
DeviceNet
Commissioning and parameterisation use:
The FCT software package and the CMMS−ST plugin via
the RS232 interface
Note
This brief overview is a part of the documentation
package. It is for initial information only and does not
replace the complete documentation, which is con
tained as a PDF file on the CD ROM supplied. The latest
version can also be downloaded from
(www.festo.com).
S You must unconditionally observe the information
and the safety instructions in the complete manual
of the motor controller.
S Please consult your local Festo Service or write to the
following e−mail address if you have any technical
problems: service_international@festo.com
Festo P.BE−K−CMMS−ST−G2 1008NH English
instructionsEnglish
17