CARE Notice 55550 Velo Manual Del Usuario página 12

Warning: The safety level of the equipment can be maintained only if it is examined regularly for damaged
and wear out parts, e.g. the connection points.
Malfunction
No resistance when
exercising or show E2
Power off
Messy code
Base is unstable.
Handlebar or seat
cushion is shaking.
Loudly noise from the
moving parts.
No resistance when
riding the upright
bike.
Cardio – Training:
Before programming your training, it is essential to take account of your age, particularly for people of more
than 35 years of age, as well as your physical condition. If you have a sedentary lifestyle without regular
physical activity, it is vital that you consult your doctor to determine the level of intensity of your training.
Once determined, do not attempt to achieve your maximum during the first training sessions. Be patient;
your performance will quickly improve.
Cardio – Training:
This enables you to develop your cardiovascular system (fitness of the heart / blood vessels). During Cardio-
Training, the muscles need a supply of oxygen and nutritive substances. They also need to eliminate waste. Our
heart increases its rhythm and sends a larger amount of oxygen to the body by means of the cardiovascular
system. The more often you exercise regularly and repetitively, the more your heart will develop, just like any
other muscle. In daily life, this translates into the ability to bear greater physical effort and improve your
intellectual faculties.
Definition of your work Zone:
The Maximum Heart Rate (MHR) = 220 - age (180 – age for sedentary people).
The Warming Up Zone and Cooling Down Zone are equal to 55% of your MHR.
The Fat Loss Zone is between 55 / 65% of your MHR.
The Aerobic Zone is between 65 / 85% of your MHR.
The Anaerobic Zone is between 85% of your MHR and your MHR.
Make a diagram of the target zones
Reason
1.Tension control is damaged.
2. Motor is failure
1.Power adapter failure
2.Wire not energized
3.Computer damaged
1.Voltage unnormal
LCD not connect with circuit
board well
3.LCD or circuit board damaged
Floor is not flat or there is small
object under the front or rear
stabilizer.
The front and rear base feet have
not been leveled when
assembling.
The screws and round knob are
loose.
The interval of the parts is
improper tightened.
The interval of the magnetic
resistance increases.
Tension control is damaged.
Running belt is slip.
Treatment
1.Replace tension control
2.Replace motor
1.Check the adapter if output DC9V
2.Use the Multimeter diode file to determine
whether the line is through, if not, replace the
connector line.
3. Check if the voltage of circuit board s
normal, if so, replace the computer.
1.Check the voltage of computer
2.Reinstallation the circuit board of computer
3.Replace the circuit board and LCD
Remove the object.
Adjust the front and rear base feet.
Tighten the screws and round knob.
Open the covers to adjust.
Open the covers to adjust.
Change the tension control.
Open the covers to adjust.