Technical Specifications - Joycare JC-350 Manual De Instrucciones

Allow the appliance to cool down and then drain the remaining liquid from the container, making it pour out of the evaporator's
container.
Take overall care to ensure that no liquid enters the appliance through the knob, the network cable or the bottom of the appliance.
After use, clean the device with water and mild soap and thoroughly dry the container and mask each time they are used, to
prevent a build-up of grease and other residues. This will ensure the maximum effectiveness and prolonged the life cycle of the
appliance.
Before using the appliance again, cool it down completely.
NEVER PLACE THE BASE OF THIS APPLIANCE IN WATER, SINCE THIS WOULD DAMAGE THE APPLIANCE. Never use abrasive clea-
ners, chemicals or brushes. Empty the container and dry with a soft cloth. Clean the base of the appliance with a soft, damp cloth
and dry with a soft cloth. Do not attempt to repair the appliance yourself. If it is not working properly always contact an authorized
service centre. The appliance must always be cleaned after use to prevent the accumulation of grease and other residues.
SYMBOLS
Do not use this appliance near bathtubs, showers, sinks or other water containers.
Class II appliance
Attention: hot water vapour
This appliance complies with all applicable European directives.

TECHNICAL SPECIFICATIONS

Power 80-100 W
Power supply: 110-240 V 50/60 Hz
Resistance PTC
Operation use conditions:
Room temperature: from 10°C to 40°C
Relative humidity: from 30% to 75% without condensation.
Pressure: from 700 – 1060 hPa
Environmental transportation and storage conditions:
Temperature: from 10 to 40°C
Humidity: from 5 to 95%
Pressure: from 700 – 1060 hPa
DISPOSAL
The appliance, including its removable parts and accessories, should not be disposed of along with domestic waste at
the end of its life cycle, but in accordance with European Directive. Since it needs to be treated separately from dome-
stic waste it must be taken to a recycling centre for electrical and electronic equipment or returned to the dealer when
buying a replacement. Severe penalties are applicable for non compliance with these requirements.
All the instructions and designs are based on the latest information available when this manual was printed, and they may be
subject to variations.
8