Start-up
Connecting the foot pedal
CAUTION!
Risk of injury!
Improper handling of the sewing machine may result in injury.
− Check that the on/off switch is not pushed in when
connecting and using the foot pedal!
− Make sure that nothing is on top of the foot pedal when
the sewing machine is not in use!
You can control the sewing machine when the sewing starts and stops by using
either the on/off switch
− Insert the foot pedal's DC connector into the foot pedal's DC connector
28
terminal
floor.
The sewing machine will start sewing when you press the foot pedal with your
foot. The sewing machine will stop sewing when you lift your foot off the foot
pedal.
Threading the upper thread
• When selecting thread, please make sure that the thread
• If the sewing machine is delivered pre-threaded, make sure
The sewing machine has two upper thread holders: the bobbin holder
which you can use to attach bobbins
use to attach any spools of thread.
For a three-thread seam (two upper threads and one lower
thread), use both holders at the same time. The spool pin's
thread will be threaded together with the bobbin holder's
thread.
1. Place the sewing machine on a table or other level, dry surface.
2. Depending on the holder you'd like to use, please follow the instructions
provided hereinafter:
16
or the foot pedal
10
on the sewing machine and place the foot controller on the
is suitable for sewing machines. An unsuitable thread can
quickly tear when sewing.
to take a good look at the thread guide before changing the
thread.
22
.
and the spool pin
25
6
3
which you can