Using The Stand/Wall Mount; Wall Mount - ResMed RCM1 Manual Del Usuario

Setup
Refer to illustration E.
RCM can only be connected to one ventilation device at a time.
1. Connect RCM to the power using the PSU. The Power indicator will illuminate.
2. Position RCM where the Signal indicator shows that you have network reception, and ensure
that RCM is:
• more than 0.8" (2 cm) away from the body during operation.
• in an area that will not be affected by moisture.
• ideally 12" (30 cm) away from the ventilation device or other electrical equipment and 3'3"
(1 m) from mobile communication devices.
3. Secure RCM with the stand or wall mount. (Refer to the Using the stand/wall mount section.)
4. Connect one end of the USB cable to the micro USB port of RCM, and the other end to the mini
USB port at the rear of the powered-on ventilation device (refer to the illustration). Ensure that
the Vent. Input indicator illuminates.
5. To ensure correct times are shown in AirView, ensure that the clock on the ventilation device is
correct (change if appropriate).
Notes:
• For further assistance, contact your care provider or ResMed representative.
• To stop RCM, unplug the power cord from the power outlet.

Using the stand/wall mount

Stand
Refer to illustration F.
1. Place the stand on a stable level surface.
2. Insert the longer edge of the stand into RCM, ensuring that it clicks into place.
3. To remove the stand, release the clip on the stand.

Wall mount

Refer to illustration G.
Use appropriate fittings to attach the wall mount. For example, use the round holes or the slots of
the wall mount for screws or cable ties (not provided).
WARNING
Ensure that the wall mount is securely fixed in place.
1. Hold RCM at an angle and push it onto the wall mount. Adjust the angle to fit RCM in place.
2. Turn RCM clockwise until it clicks into place.
3. To remove RCM from the wall mount, turn it counterclockwise.
English 3