Install The Upper Handle; Install The Grass Catcher; Install The Mulch Plug; Install The Side Discharge Chute - GreenWorks G24X2LM46S Manual Del Operario

EN
Do not make damage to the cables when you fold or unfold
the handle.
6.3

INSTALL THE UPPER HANDLE

Figure 3
1. Align the holes in the upper handle and the lower handle.
2. Put the bolts through the holes.
3. Tighten the knobs onto the bolts.
4. Do the same operation on the other side.
6.4

INSTALL THE GRASS CATCHER

Figure 4
1. Remove the mulch plug.
2. Remove the side discharge chute.
3. Open the rear discharge door and hold it.
4. Hold the the grass catcher by its handle and engage the
hooks on the door rod.
5. Close the rear discharge door.
6.5

INSTALL THE MULCH PLUG

Figure 5.
1. Remove the grass catcher.
2. Open the rear discharge door and hold it.
3. Hold the mulch plug by its handle and fit it in the
discharge chute.
4. Close the rear discharge door.
6.6 INSTALL THE SIDE DISCHARGE
CHUTE
Figure 6
When you use the side discharge chute,
• do not install the grass catcher.
• keep the mulch plug installed.
1. Open the side discharge door and hold it.
2. Line up the recesses of the side discharge chute below the
pivot.
3. Close the side discharge door.
6.7

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
Figure 7
1. Pull the height adjustment lever rearward to increase the
blade height.
WARNING
CAUTION
English
2. Pull the height adjustment lever forward to decrease the
blade height.
6.8

INSTALL THE BATTERY PACK

Figure 8
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
USE ONLY 24V BATTERY. DO NOT USE DUAL-
VOLTAGE 24/48V BATTERY.
Both batteries should be installed into the compartments in
order to start the machine.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Do the same operation with the other battery.
6. Close the battery door.
The motor starts only when you put in the safety key.
6.9

REMOVE THE BATTERY PACK

1. Open the battery door.
2. Remove the safety key.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.
7

OPERATION

Wear eye protection during operation.
7.1

START THE MACHINE

Figure 9
1. Put in the safety key.
2. Push and hold the start button.
8
WARNING
WARNING
NOTE
NOTE
WARNING