Troy Lee Designs A2 Manual Del Propietário página 15

INSTRUCTIONS
1. Always wear your helmet about 1 inch (2.54
cm) above your brow to protect your forehead;
helmet should be in a level position across your
forehead and ears, left to right and front to back.
2. Helmet should not be worn tilted back
exposing your forehead. Strap should not be
loose and out from under your chin.
3. Semi adjustable side strap allows slight
adjustment to remove slack in the front or back
strap lengths. Depending where the slack is this
might affect where the chinstrap lands under
your chin and location of the strap across the
side of your face. A well-adjusted strap should be
taught on front and back and land in a centered
and comfortable location underneath your chin.
4. To loosen/add length to front strap and
remove extra strap slack at the rear feed rear
strap through side strap divider hole and pull
through back side feeding strap up and into the
front strap hole, increasing the front strap
length. To lengthen rear strap or remove slack in
the front reverse strap feed process.
5. Secure chin strap snap by pushing opposite
ends together. A click sound will make sure you
have the chin strap buckle securely fastened.
Push inward on side prongs to release chin strap
buckle.
Be careful that your neck does not get pinched
from chin strap snap. The buckle should be
positioned away from the jawbone. Make sure
to tighten the chin strap well back against the
throat and NOT on the point of your chin. Straps
worn too close to the chin increases the chance
of the helmet coming off during an accident.
6. Adjust chin strap tightness by feeding strap
through pulling at opposite end. Wrap excess
strap under rubber grommet. Not securing the
loose ends with the rubber grommet can result
in the helmet coming off accidentally.
7-8. Twist stabilizer wheel (at rear of helmet)
clockwise to tighten against the back of the
head. Tighten until helmet fits snug and secure-
ly. Twist stabilizer wheel counter-clockwise to
loosen tension against back of head to remove
helmet.
9-10. Adjust stabilizers reach on back of head by
gently pulling out end of arm protruding into
helmet shell. Locate the end of the stabilizer ball
mount in one of the three holes for desired fit.
Push to click for secure mounting.
11-12. Adjust position of front stabilizer arms by
gently pulling inward from helmet side
release snap. Locate the end of the arm ball
mount in one of the three holes for optimal fit
and arm position behind ears. Push to click for
secure mounting.
to