Troy Lee Designs A2 Manual Del Propietário página 16

EN
CHECK THE FIT: Before using the helmet, make sure that it fits correctly, it is positioned to cover
your entire forehead, the straps are correctly adjusted, and the chin strap is tight. Grab the helmet
with both hands and twist it to the left and right. If the helmet fits correctly, the skin on your
forehead will move as the helmet moves. If the skin on your forehead does not move, the helmet is
too loose.
CHECK THE STRAPS: With the helmet on and the chin strap buckled, grab the helmet with both
hands and try to remove it by rolling the helmet forward and backward as far as you can. Make a
serious effort. If you can roll/push the helmet off the head completely in either direction or roll it
forward so far that it blocks vision or backwards so far that it exposes the forehead, YOUR
HELMET DOES NOT FIT CORRECTLY. Repeat STEPS above until helmet movement is minimal.
TEST RIDE: Once you are satisfied that the helmet fits correctly and that all straps are properly
adjusted, tightened, and secured, take a short bicycle ride in a area free from traffic and other
hazards. Pay attention to overall comfort and stability while riding. Make minor adjustments to the
fit pads and straps to improve comfort and stability. DO NOT make any adjustments to the helmet
while riding as this could cause you to loose control of the bike or cause the helmet to fall off and
become damaged or entangled in your wheels causing a crash.
VISOR ADJUSTMENT INSTRUCTIONS
13. Remove all 3 aluminum bolts to remove visor. Twist bolts counter-clockwise to loosen.
14. Adjust visor by turning center bolt counter clockwise and moving visor to desired height.
Re-tighten bolt turning clockwise to secure. DO NOT over torque as this can permanently damage
the helmet (making it unsafe) or damage the visor.
LINER INSTRUCTIONS
15. Install liner using specifically located Velcro mounting points. Liner will stick to Velcro and hold
liner into position.
16. Insert liner into shell by starting at the front of the forehead securing the liner to Velcro
mounts as you work to the back of the helmet. (see diagram for positioning of liner) Liner can be
trimmed in 2 locations to adjust fit and increase airflow. Use scissors and trim on marked lines
only. Removing padding may cause fit issues on some types of head shapes.
INSTRUCTIONS